Equipment protection task, not only can usefully extended mechanical practice life, reduce the equipment trouble rate, to save from capital, and it also can improve product quality, finally complete the same, and the fruit of the efficient. In this paper, the author in view of the linear guide laser equipment, mirror, mirror, bearing the key parts and components, such as through shallow to read as we introduced the fundamental protection methods of laser equipment.
In the modern clothing production, carved machine, cutting machine, etc to increasingly focus on laser processing equipment, widely used in all kinds of clothing product produce process. How ability can laser equipment the same tasks running normally, better promote its working efficiency? Laser equipment daily protection task crucial. In order to make the vast clothing enterprise customers better use the laser equipment, the following the author is the root of the laser equipment protection measures were briefly introduced, I wish for you to supply beneficial help.
Linear guide smooth filling oil Laser equipment use after period of time, carving, cutting incidental smoke, dust has the erosion effect on the guide rail, so should be the guide for their own protection. We can close the power of the laser machine, with clean soft cloth will guide clean clean, then smooth on the guide rail on drop too much oil. After the smooth oil, we should let the slider on the guide rail repeat rolling back and forth several times, in order to ensure smooth oil equipment into the interior of the slider. Keep in mind, the smooth finish oil again let the slider back and forth on the guide rail rolling process, must first put rail mount at this moment, pay attention to guide if it don't fixed, but to put nail fixed all good, insist on. Also, we should also put the belt and the sliding block is fixed, and then put the lens is good, dimming the X in the way, until the end.
Gathered mirror, mirror clean Laser cutting machine or carve machine in use after period of time, the surface of the lens will smoke dust adhesion in, can affect the carve, cutting depth and precision. We suggest, about a week (on the basis of laser cutting machine, carving machine USES frequency) with anhydrous alcohol three pieces of reflector, a lens carefully wipe clean.
Bearing oiling All the laser equipment are used a lot of bearing, for the sake of guaranteeing the superior cutting, carving as a result, local bearing demand timely refueling (except oil bearing). We can use a clean soft cloth to rub on bearing eluvial soil loss, the oil suction needle by needle, then slowly with the needle inject oil bearing, slow shift when filling in the bearing.
Synchronous belt elastic adjustment In the transmission system of laser carving machine, cutting machine, there are several of the synchronous belt, if synchronous belt is too loose, easily render carved font rendering ghosting conditions; If synchronous belt is too tight, easily forming synchronous belt wear. In use after a period of time, we should adjust the synchronous belt tensioning screw, adjust the synchronous belt to the consistence of the status, so much word not sculpted by ghosting, and laser carving machine, laser cutting machine is running to very low noise is advisable.
