No, carved deep: 1, a luminous moment is not deep, first check whether the laser tube bearing point, strong light set is too small, light path is offset, the focal length is correct, reflection lens surface whether there is scratches and dirt, the flow of cooling water flow pressure is normal, more than a few right. A: continuous laser discharge tube filling at the time of the light color is white, is the power attenuation caused by gas consumption. (when the normal work of the laser tube filling discharge color for the pink)
B: for a light laser tube discharge in deep purple color, inner core is the laser tube slow leak. 2, glow for a moment to moment is not deep, this problem should first check the laser tube bearing point is reasonable, whether the water temperature more than 30 degrees, the lens at work if fever, the flow of cooling water flow pressure is normal, the cooling water is clean, the above normal and then check the laser tube. Inspection of a light, high pressure and discharge: is there a dirt around the high pressure head and moist, away from the machine metal parts is too close; The other is Whether the laser power supply high voltage connection fell off from the pedestal, high pressure connection devices inside is break and damage. If the above normal the laser tube is itself a flat.Three, laser tube, crack, water head loss: 1. If the water temperature control at 25 ℃ and 30 ℃, cooling water shall not be frozen cold regions, especially the laser after downtime, must not let water stored in the laser tube. 2. The light is under the control of water conservation work; (will test the light on and off with water or not blinking) 3. The water pipes have the phenomenon of discount. 4. The laser tube will have bubbles. 5. The water pressure water flow is normal; In the direction of flow is higher than that of low into. 6.1-5 normal word the laser tube is itself quality problems. Read carefully before use and replace the laser tube above content, avoid the wrong operation cause unnecessary losses.
